Do You Know the Detailed Steps of the Accumulate Blow Molding Machine Startup Process?

Cleaning: Before using the Accumulate Blow Molding Machine, the equipment should be cleaned first to ensure the hygiene and quality of the products produced. The specific cleaning method is as follows: clean the dust and impurities inside and outside the blow molding machine; use clean water or detergent to clean the machine, and be careful not to let water enter the electrical part; rinse thoroughly with clean water until it is clean.

Feeding: The method and steps of feeding the blow molding machine are as follows: open the hopper and add an appropriate amount of raw materials; turn on the heater and adjust the temperature to a suitable heating temperature; start heating and wait for the raw materials to melt; adjust the speed of the feeder so that the raw materials enter the blow molding machine evenly.

Adjust the temperature: The Accumulate Blow Molding Machine needs to work at a suitable temperature to produce high-quality products. The temperature adjustment needs to be carried out according to the specific situation, but generally speaking, the steps for adjusting the temperature are as follows:

Turn on the heater and adjust the temperature to a suitable heating temperature; wait for the heater to reach the set temperature and start production.

Start the screw: Press the start button on the extruder control panel to start the screw, and turn the screw temperature control knob on the extruder control panel to set the screw speed. Start the motor pump: Press the start button on the blow molding machine control panel to start the electric pump. Set the working mode: Turn the mode selection switch on the blow molding machine control panel to switch to the fully automatic working mode. Start the blow molding cycle: When the material flowing out of the die head reaches the appropriate length, press the start button on the blow molding machine control panel to start the mold closing action.

When using the blow molding machine, you need to pay attention to the following matters:

Keep the equipment clean and sanitary, clean it regularly; before using the equipment, check whether the machine is operating normally; when adding materials, ensure the quality and quantity of the raw materials; when adjusting the temperature, adjust it according to the specific situation; during the production process, pay attention to safety and avoid accidents.

Using the Accumulate Blow Molding Machine requires carefulness and patience, and only by following the correct operating methods can high-quality products be produced. I hope this article can help readers.